JL Audio RD1000/1 Monoblock Class D Amplifier 1000W RMS

Mono Class D 100WRMS Amplifier

The Monoblock RD1000/1 is capable of pushing out up to 1,000 watts of clean power at 2 ohms, this subwoofer amplifier handily powers all the low end you can stand. The RD Monoblocks have built-in 12 dB/octave low-pass filters, bass equalizer boosters and three turn-on modes: Traditional 12-volt trigger, signal sensing and DC offset. Top off the package with a sleek, single-cast piece of aluminum in black powdercoat and blue LEDs, and your power looks as clean as it sounds.

JL Audio’s engineers had professional and at-home installers in mind with the RD Series. All of the inputs and controls are on the same side of the chassis, simplifying the setup whether you’re in a shop or in your driveway. The output clipping indicators on each channel section mean you don’t need specialized tools to accurately set the gain. A remote level control input gives you the option to install a bass level knob, sold separately, in the front seat, giving you full control over the bass output for every song you play.

The RD Series also incorporates JL Audio’s NexD Switching Tehnology. Since Class D amplifiers have a tendency to produce distortion at some ranges, NexD Switching helps cancel it out before feedback is ever applied. All of this helps ensure the some of the cleanest possible signal to your subwoofer from your brand new Class D amplifier.

Specifications

General Specifications

• Mono subwoofer amplifier
• 600 watts RMS x 1 at 4 ohms (1000 watts RMS x 1 at 2 ohms)
• Class D amplifier design with NextD™ switching amp technology
• Differential-balanced inputs help eliminate noise
• Variable low-pass filter (50-500 Hz, 12 dB/octave)
• Variable bass boost (0-12 dB at 45 Hz)
• LED clip light helps set gain

Signal Processing

• Blue LED accent lighting
• Optional wired remote level control
• Preamp inputs and outputs
• Speaker-level inputs (speaker wire to RCA adapter required)
• 4-gauge power and ground leads and a 80-amp fuse recommended — wiring and hardware not included with amplifier
• No onboard fuses — when installing multiple amps in a system, an additional 80-amp in-line fuse between the distribution block and the amplifier is recommended
• 14-5/8"W x 2-3/16"H x 7"D