JL Audio RD900/5 900W RMS 5 Channel Class D Speaker Subwoofer Amplifier

5 Channel Class D 900WRMS Amplifier

The RD900/5 is capable of pushing out up to 75 watts of clean power to 4 channels at 4 ohms, plus another 500 watts at 2 ohms to your sub, this amp has the flexibility to push your cabin speakers, your subwoofers, or a combination of them depending on your needs. The RD multi-channel amps have built-in 12 dB/octave low-pass filters and three turn-on modes: Traditional 12-volt trigger, signal sensing and DC offset. Top off the package with a sleek, single-cast piece of aluminum in black powdercoat and blue LEDs, and your power looks as clean as it sounds.

JL Audio’s engineers had professional and at-home installers in mind with the RD Series. All of the inputs and controls are on the same side of the chassis, simplifying the setup whether you’re in a shop or in your driveway. The output clipping indicators on each channel section mean you don’t need specialized tools to accurately set the gain. A remote level control input gives you the option to install a bass level knob, sold separately, in the front seat, giving you full control over the bass output for every song you play.

The RD Series also incorporates JL Audio’s NexD Switching Tehnology. Since Class D amplifiers have a tendency to produce distortion at some ranges, NexD Switching helps cancel it out before feedback is ever applied. All of this helps ensure the some of the cleanest possible signal to your subwoofer and speakers from your brand new Class D amplifier.

Specifications

General Specifications

• 5-channel car amplifier
• 75 watts RMS x 4 + 225 watts RMS x 1 at 4 ohms
• 100 watts RMS x 4 + 500 watts RMS at 2 ohms
• 200 watts RMS x 2 bridged at 4 ohms (4-ohm stable in bridged mode) + 500 watts RMS at 2 ohms
• Class D amplifier design with NextD™ switching amp technology
• differential-balanced inputs help eliminate noise
• variable high-pass filters (50-500 Hz, 12 dB/octave) on front and rear channels
• variable low-pass filter (50-500 Hz, 12 dB/octave) on subwoofer channel
• LED clip lights help set gain

Signal Processing

• Blue LED accent lighting
• Optional wired remote level control for subwoofer channel
• Preamp and speaker-level inputs (speaker wire to RCA adapter required for speaker-level input)
• 4-gauge power and ground leads and 80-amp fuse recommended — wiring and hardware not included with amplifier
• No onboard fuses — when installing multiple amps in a system, an additional 80-amp in-line fuse between the distribution block and the amplifier is recommended
• 14-11/16"W x 2-3/16"H x 7"D